|
|
|
 |
Traffic Spikes / Tiger Teeth / Cobra Factory Authorized Distributor for RoadBlade, PMG, Magnetic Autocontrol, and DoorKing, DKS. Competitive pricing. Worldwide distributor for Road Shark and RoadShark Traffic Spikes. Checkpoint TRAP (temporary roadblock apparatus pack) and permanent tire shredders. Feel safer with one-way traffic spike systems, road traffic control systems, retractable tire traffic spikes, (1610, 1615, 1601, 1602, 1603, auto-spike), super heavy duty traffic spikes, RB-36 traffic spikes, RB-36LD latch-down traffic spikes, Cobra traffic spikes, Cobra II traffic spikes, StingRay traffic spikes, Enforcer traffic spikes, RoadShark traffic spikes, spike strips for both in-ground and on-ground directional treadle systems for in-bound and out-bound pneumatic tires. We sell at discount to apartment complexes, shopping center, malls, airports, military bases/installations, factories and businesses to protect parking lots, employee, security, and public access, private and commercial property. Traffic Spikes can be your guardian. Tire poppers are one-way, two-way, above ground, on ground, flat mount, flush mount, or surface mount... hydraulic options.
|
|
|
 |
|
|
|
|
 |
 |
|
DoorKing's traffic control products are for controlling one way traffic. Model 1610 DoorKing Flush Traffic Control Spikes require trenching for in-ground installation. Model 1610 DoorKing Surface Traffic Control Spikes mount directly onto concrete. These traffic spikes allow vehicular travel in one direction only. DoorKing traffic control spikes are frequently used to enforce one way traffic in a single traffic lane, such as the entrance or exit to parking facility (parking garage or lot).
Model 1615 Warning Sign for DoorKing traffic spikes should always be used whenever a traffic spike set is installed in a roadway. This sign provides a way to inform vehicular traffic that a one way lane condition exists and that severe tire damage may result if they proceed incorrectly. The red side of the sign warns traffic to stop and the green side of the sign warns traffic not to back up. The sign is illuminated by two fluorescent bulbs that automatically turn on at dusk and turn off at dawn. A flood lamp is used to illuminate the DoorKing traffic spikes during night-time hours.
The 1610 and 1615 DoorKing traffic control spikes make an ideal complement to DoorKing Barrier Gate Operators. Model 1610-150 Speed Bump is recommended when using the traffic spikes to keep vehicle speeds to 5 mph (the maximum recommended speed to prevent damage to traffic spike units and vehicle tires. DoorKing offers a manufacturer's 1 year warranty on traffic spikes and signs.
|
 |
 |
|
FEATURES:
- The 1610 series DoorKing traffic spikes are for one way directional traffic control.
- Each DoorKing spike is individually spring loaded using stainless steel springs.
- A counterweighted DoorKing spike model is available, using no springs.
- DoorKing models are available with lock-down feature. Lock-down handle locks spikes in down position, removable handle is included.
- 150 watt flood lamp illuminates DoorKing traffic spikes at night with the use of DoorKing sign.
- The DoorKing flush-mount model top plate and spikes are painted bright red for easy visibility.
- The DoorKing surface mount model is bright yellow and has red spikes.
- DoorKing model 1615 traffic sign uses 2 qty. 20 watt fluorescent lamps for night illumination.
- The DoorKing light sensor turns on at dusk and off at dawn. the bulb saver extends the life of the flood lamp.
- DoorKing model 1610-150 speed bumps help to keep traffic slowed down to recommended 5 mph (available separately).
- 1610 Spec Sheet 1 1610 Spec Sheet 2
NOTE: Warning signs must be used with DoorKing traffic spikes to warn drivers that a one-way traffic condition exists. Speed bumps should always be used with DoorKing traffic spikes. Speeds in excess of 5 mph over spikes can cause tire damage. All of our DoorKing products are sold separately to better accommodate your needs.
|
 |
|
|
 |
 |
 |
|
DOORKING FLUSH MOUNT TRAFFIC SPIKES
MOUNTING: Flush to the roadway, in ground unit.
SPRING LOADED SPIKES: Each DoorKing spike is individually spring loaded with a stainless steel spring.
OPTION / WEIGHTED SPIKES: Weighted DoorKing spikes (no springs) version is available.
HOUSING: Steel top plate and DoorKing spikes are painted bright red for easy visibility.
VEHICLE SPEED: The maximum speed over the DoorKing spikes is 5 MPH. Excessive speed can result in damage to DoorKing traffic spikes and vehicle tires. The use of speed bumps to control traffic speed is highly recommended.
|
DIMENSIONS:
|
Height: 6.5 in. Width: 8.5 in. Length: 6 ft.
|
|
FOOTPRINT: 72 inches long x 12 ˝ inches wide.
RECOMMENDED TRENCH SIZE: 72 inches long x 16 - 20 inches wide x 9 - 12 inches deep.
WEIGHT: Approximately 130 pounds.
WARNING SIGN: Recommended to warn traffic for safety reasons. Sold separately.
|
|
|
 |
|
|
 |
 |
 |
|
DOORKING SURFACE MOUNT TRAFFIC SPIKES
MOUNTING: On-surface, concrete mount.
SPRING LOADED SPIKES: Each DoorKing spike is individually spring-loaded with a stainless steel spring. DoorKing spikes are painted bright red to contrast with the yellow housing.
HOUSING: Steel housing is painted bright yellow for easy visibility.
SPEED: The maximum recommended vehicle speed over the DoorKing spikes is 5 MPH. Excessive speed can result in damage to the DoorKing unit and to the vehicle’s tires. The use of speed bumps to control vehicular traffic speed is highly recommended.
|
DIMENSIONS:
|
Spike Section: Height: 3 in.+ spike Width: 31 in. Length: 3 ft.
|
End Cap: Height: 3 in. Width: 31 in. Length: 12.25 in.
|
|
FOOTPRINT: 36” long x 31” wide.
WEIGHT: 3' Spike Section is approximately 164 lb.; End Caps (pair) 26 lb.
WARNING SIGN: Recommended and sold separately from traffic spikes.
This units include the lock-down feature to lock the DoorKing spikes in the down position to allow two-way traffic (ideal for move-ins and move-outs). Removable handle is included with your order.
|
|
|
 |
|
|
 |
 |
 |
|
DOORKING WARNING SIGN
INPUT POWER: 110-120 VAC, 60 HZ, Single Phase.
CURRENT: 1.75 Amp @ 115 VAC.
SIGN ILLUMINATION: Two (2) 20 Watt Fluorescent Lamps.
SPIKE ILLUMINATION: 150 Watt Flood Lamp - extends approximately 7” below the sign.
LIGHT SENSOR: Automatically turns ON at dusk, OFF at dawn. A keyed switch allows manual operation of the lighting system.
HOUSING: The galvanized steel housing is painted white.
MOUNTING: DoorKing signage is designed to be mounted on a 3 in. mounting post (available separately).
|
DIMENSIONS:
|
Height: 24 in. Width: 24 in. Depth: 8 in.
|
|
WEIGHT: Approximately 48 pounds.
LISTING: ETL Listed.
|
|
|
 |
 |
|
SPEED BUMP
MOUNTING: Designed for mounting onto concrete surfaces. It can be easily removed and re-installed. Mounting anchors are included.
MATERIAL: Solid composite. Painted bright yellow.
|
DIMENSIONS:
|
Height: 2 in. Width: 11.5 in. Length: 6 ft.
|
|
WEIGHT: Approximately 28 lb.
|
|
|
 |
|
|
 |
 |
|
|
|
|
|
|
DKS model 1603 Barrier Gate Operator / Automated Spike System is designed as a modular system allowing for easy flexibility in different applications and easy installation. The DoorKing 1603 operator is designed with many advanced features and mechanically links the spikes to the barrier arm. The surface mount spikes are easy to install and do not require any trenching or excavating. The 1603 DoorKing auto-spike system is ideal for parking lots, rental car agencies, schools, car dealerships, government agencies, or in any application where a higher degree of traffic control is preferred. This system is designed to mount to a level concrete pad.
A complete DoorKing 1603 / auto-spike system consists of several different components. A typical system will require a DoorKing 1603 operator, DoorKing transfer box (DoorKing transfer box is factory installed to the DoorKing 1603 operator), DoorKing tunnel section(s) as needed, DoorKing spike section(s) as needed, plus DoorKing end caps. A DoorKing traffic signal and/or DoorKing warning sign is required with this DoorKing system.
|
|
|
|
|
|
|
|
|
|
|
|
|
15.25"W x 43.75"H x 14.75"D
|
31"W x 3"H x 36 or 72"L
|
|
|

|

|
|
|
|
|
|
|
|
|
- Magnetic limit control.
- Ports for plug-in loop detectors.
- Automatic sequencing inputs for use with slide and swing gate operators.
- Up input memory buffer.
- Down memory option.
- Multiple up commands.
- Two convenience outlets.
- Gate tracker reporting output.
- Programming switches.
- Built-in power On/Off switch.
- Left or right hand mount.
|
|
|
|
|
- 1/2 HP continuous-duty motor.
- 115, 230, 460 VAC. (*230 and 460 volt units use a step-down power transformer to achieve 115 volt operating voltage.)
- 40:1 gear-box running in a continuous oil bath.
- Arm rotates 90° in approximately 1.5 seconds.
- Class II, III and IV applications.
- Compliant with UL 325 and 991. (To be compliant with UL 325 and industry safety guidelines, additional secondary entrapment prevention devices may need to be installed with this gate operator.)
- Dimensions: 15.25"W x 43.75"H x 14.75"D.
|
|
|
|
|
- Tunnel sections surface mount: 31"W x 3"H x 24 or 36"L
- Spike sections surface mount: 31"W x 3"H x 36 or 72"L
- End Cap: 31"W x 3"H x 12.25"L
|
|
|
|
|
- DC Powered convenience open.
- 14-foot round (3" dia) aluminum arm.
- 14-foot 1 x 3 inch wood arm.
- Arm folding bracket assembly for low headroom (wood arm only).
- Foam padding for arms.
- Fan Kit
- Heater Kit
- Plug-in loop detectors.
- Surge suppressors.
|
|
|
|
|
|
 |
|
All content is copyright protected by Monsoon Manufacturing LLC. Nite-BiteTM is a trademark of Monsoon Manufacturing LLC and has a patent pending through provisional patent filed with the United States Patent Office. RoadShark and TrafficSpyker are brands of traffic safety equipment in the USA ( by Monsoon Manufacturing LLC)
We reserve the right to alter design specifications without prior notification (we upgrade finishing techniques and manufacturing processes as they become available).
Disclaimer: All sales are final. Contact the webmaster at: Jeff@TrafficSpikesUSA.com
|
|
|